The cleaning of the Vonci brand blender can be done by following these steps:

Find a stable, clean, and easy-to-operate countertop. Avoid cleaning in places where the water source is unstable or where water is likely to splash to prevent the blender from accidentally getting water inside and damaging key components such as the motor.

Prepare a clean soft cloth, mild neutral detergent, a small brush (such as a toothbrush or a soft-bristled cleaning brush), a basin of clean water, and a clean towel for drying. The neutral detergent can effectively remove stains without corroding the materials of the blender.

Turn off and unplug the power to ensure that no accidental electric shock accidents occur during the cleaning process.

According to the instruction manual of the blender, remove the detachable parts such as the blending cup, blades, and blending shaft one by one. Be careful not to force the disassembly to avoid damaging the parts or the blender itself. If the blades and the blending shaft of the blender are designed as an integral and non-detachable part, this step can be omitted, but more care should be taken when dealing with the blade area during subsequent cleaning.

Use a small brush or a soft cloth to first remove the obvious food residues on the blender parts. For the stubborn residues attached to the blades or the inner wall of the blending cup, you can gently wipe them with a soft cloth or dip a small brush in a small amount of neutral detergent to scrub. Wipe the outer shell of the blender with a soft cloth dipped in neutral detergent to remove the surface stains and dust. Be careful not to let water enter the power interface, switch, and other parts of the blender.

Put the disassembled blending cup, blades, and other parts into a basin filled with warm water and an appropriate amount of neutral detergent and soak them for a period of time to allow the detergent to fully dissolve the dirt attached to the parts. The soaking time is usually 15 to 30 minutes, but if there is more dirt or it is more stubborn, the soaking time can be appropriately extended.

After soaking, use a soft cloth or a brush to carefully clean the inner wall and bottom of the blending cup to ensure that all the dirt is removed. For the corners that are difficult to clean, you can use a small brush or a cotton swab for assistance. If the blades can be disassembled, take them out of the soaking solution and use a small brush to gently scrub both sides of the blades and the blade edges. Be careful not to scratch your fingers. If the blades are not detachable, use a small brush to carefully scrub the areas around the blades in the soaking solution, but avoid the blades from scratching the soft cloth or the brush.

Rinse the cleaned blender parts thoroughly with clean water to ensure that all the detergent residues are rinsed off.

For the outer shell rinse: Dip a clean wet cloth in clean water and wipe the outer shell of the blender again to remove the remaining detergent.

Place the cleaned and rinsed blender parts and the outer shell in a well-ventilated place to dry them, or use a clean towel to dry them. Make sure that all the parts are completely dry before assembling them to avoid any remaining water causing problems.